Using 3M™ Elipar™ DeepCure-S LED Curing Light.
The patient came in with primary decay on the distal of tooth #12 with occlusal groove involvement. The curing light, 3M™ Elipar™ DeepCure-S LED Curing Light, was tested using a Bluelight CheckUp Radiometer and was found to have an irradiance of 1084 mW/cm2. This pre-testing guarantees efficient adhesive and composite polymerization and a high-quality restorative procedure. After isolation with a rubber dam, the caries was removed, and the cavity was prepared. Then, the adhesive protocol was realized using 3M™ Scotchbond™ Universal Plus Adhesive and the tooth was restored with 3M™ Filtek™ One Bulk Fill Restorative, Shade A2. Once occlusion was adjusted, the restoration was polished using a medium grit 3M™ SofLex™ Contouring and Polishing Disc followed by the 3M™ SofLex™ Diamond Polishing System. The beige pre-polishing spiral was used on a wet surface, followed by the pink polishing spiral.
The 3M™ Elipar™ DeepCure-S LED Curing Light was tested with a Bluelight CheckUp Radiometer, finding an irradiance of 1084 mW/cm2.
The initial situation showed the primary decay on the distal of tooth #12 with occlusal groove involvement.
After isolation with a rubber dam, the caries was removed, and the cavity was prepared.
37% phosphoric acid etch gel was applied to the enamel using the selective-etch technique, left on for 15 seconds, then rinsed with water.
After etching for 15 seconds, rinsing, and drying, 3M™ Scotchbond™ Universal Plus Adhesive was rubbed in for 20 seconds, then air-dried and light-cured with the 3M™ Elipar™ DeepCure-S LED Curing Light.
A full increment of 3M™ Filtek™ One Bulk Fill Restorative, Shade A2 was applied and sculpted into place with a thin plastic instrument.
Using a three-point method, each side of the restoration (occlusal, buccal, and lingual) was light-cured for 10 seconds.
The restoration was polished with a 3M™ Sof-Lex™ Contouring and Polishing Disc, then the 3M™ Sof-Lex™ Diamond Polishing System.
The x-ray showed a perfectly adapted restoration.
Final result.
Refer to Instructions for Use (IFU) for complete product information. Results may vary.
Using 3M™ Single Bond Universal Adhesive, 3M™ Filtek™ Supreme Flowable Restorative, 3M™ Filtek™ Universal Restorative, 3M™ Elipar™ Deep Cure-S LED…
Using 3M™ Scotchbond™ Universal Adhesive, 3M™ Filtek™ One Bulk Fill Restorative, and the 3M™ Sof-Lex™ Spiral Finishing and Polishing system.
Using 3M™ Protemp™ 4 Temporization Material, 3M™ Scotchbond™ Universal Plus Adhesive, and 3M™ RelyX™ Universal Resin Cement.
